Tarboro Plumbers Near You
Tarboro Plumbing & Drain Solutions: Licensed Tarboro Plumber Available 24/7 Providing Emergency Plumbing and Drain Services
Roto-Rooter is a licensed plumber in Tarboro, NC offering full-service plumbing repair and maintenance 24 hours a day, seven days a week. From drain cleaning to toilet clogs, water heaters to new installations, our experienced Tarboro plumbers can do it all – on your schedule. To schedule an appointment with our experienced plumbers please call our Tarboro plumbing office at 252-442-9340.
Serving the entire metro area, Including:
Counties in the Tarboro Area
Frequently Asked Questions in Tarboro
Is it safe to use my dishwasher if the kitchen drain is slow?
A slow kitchen drain means the branch line already has restricted flow. Running the dishwasher adds a significant volume of water at once, which can back up into the sink or, in worse cases, overflow onto the floor. It is better to hold off on the dishwasher until the drain is cleared. Roto-Rooter can auger the P-trap and branch line or hydro jet the line if grease buildup is the underlying cause.
Why does my basement floor drain back up when I do laundry?
The basement floor drain sits at the lowest point in the home's drainage system, so it is the first place that shows a backup when the main sewer line is partially blocked. The surge of water from the washing machine overwhelms the restricted line, and the floor drain is where it surfaces. Roto-Rooter clears the main line blockage, which resolves the floor drain backup at the source.
What should I do if a pipe bursts in the middle of the night?
Shut off the main water supply valve immediately - it is typically near the water meter or where the supply line enters the house. That stops the flow and limits damage. Roto-Rooter is available 24/7, 365 days a year, so you do not have to wait until morning. Call 252-442-9340 to reach dispatch in Tarboro, NC and get a technician on the way.
What is hydro jetting and when does a drain actually need it?
Hydro jetting sends a high-pressure water stream through the pipe to scour the walls clean of calcified grease, mineral scale, and root debris. A cable auger punches through a clog but leaves buildup on the pipe wall, so the clog often rebuilds within weeks. Hydro jetting is the right call when camera inspection shows heavy coating on the pipe interior or when the same line clogs repeatedly.
Can tree roots really get inside my drain pipes?
Yes. Roots seek moisture and enter drain lines through hairline cracks or loose joints - especially in older clay or cast iron sewer laterals. Once inside, they expand as they absorb water from the pipe, eventually causing recurring backups or a complete blockage. The Roto-Rooter Machine cuts through root intrusion, and a sewer camera inspection confirms whether the pipe wall itself has been compromised.
Why does my water heater make a rumbling noise?
Sediment - minerals that settle out of the water supply - collects on the tank floor over time. As the burner heats the water, it pops and rumbles through that layer of buildup. The sediment also acts as insulation, forcing the heater to run longer and use more energy. Roto-Rooter technicians flush the tank, inspect the anode rod, and test the pressure relief valve to restore normal operation.
What causes low water pressure throughout the whole house?
Whole-house low pressure usually points to one of three things: a partially closed main shutoff valve, a failing pressure reducing valve, or a leak somewhere on the supply line. A pressure reducing valve regulates incoming pressure to a safe household range - when it fails, pressure can drop or spike unpredictably. A Roto-Rooter technician diagnoses which component is at fault and repairs or replaces it.
What happens during a sewer camera inspection?
A technician feeds a waterproof camera on a flexible cable through the drain line to view the pipe interior in real time. The camera reveals the exact location and nature of any problem - a grease buildup, a root intrusion, a collapsed section, or a belly where the pipe sags and holds standing water. That information determines whether augering, hydro jetting, or pipe repair is the right next step.
My toilet keeps running after I flush. Is that a big deal?
A continuously running toilet can waste hundreds of gallons of water per day. The most common cause is a worn flapper that no longer seals the flush valve, letting water trickle from the tank into the bowl. A faulty fill valve can also cause the same symptom. Both are straightforward repairs - Roto-Rooter replaces the failed component and confirms the toilet cycles and seals correctly before leaving.
How do I know if I have a hidden pipe leak inside my walls?
Common signs include unexplained damp spots on drywall, a musty smell in a closed room, or a water meter that keeps moving when every fixture is shut off. Roto-Rooter technicians use moisture meters and visual inspection to trace the leak to its source before opening any wall. Finding the exact location first keeps the repair focused and minimizes unnecessary damage to your home.
My old galvanized pipes keep developing small leaks. Should I just keep patching them?
Galvanized steel pipes corrode from the inside out as they age, narrowing the interior diameter and developing weak spots along the pipe wall. Patching one leak usually means another appears nearby within months. Roto-Rooter can assess the condition of the line and, if the corrosion is widespread, replace the affected sections with copper or PEX - a longer-term fix that stops the cycle of recurring leaks.
